CODE LEARNING (Continued)
TITAN transmitter should be no less than 30cm and no more than the maximum range of 70m from the TITAN Alarm
Panel.
d) The TITAN Alarm Panel will emit a long beep to indicate that the code has been learnt.
·
If the TITAN Alarm Panel fails to learn the transmitter code repeat steps a), b), c) and d).
Also repeat steps a), b), c) and d) for each TITAN transmitter you wish the TITAN Alarm Panel to learn from. Up to the
maximum of twelve separate transmitters.
·
If you make an error during the code learning sequence, or you wish to clear the entire memory of the TITAN Alarm Panel
for another reason proceed as follows:
1) Key in your 4-digit security code
2) Press key # (the unit will now accept code clearance, the Status and Low Battery LED’s will flash to indicate this)
3) Key in your 4-digit security code again
4) Press key # again
ARMING / DISARMING ALARM PANEL
Two arming modes are available instant and entry delay. If set to instant the alarm will sound the siren immediately a coded
TITAN transmitter is triggered. If set to entry delay the alarm will sound the siren fifteen seconds after a coded TITAN transmitter
is triggered. The entry delay mode is the most common used. Both modes have a fifteen second exit delay.
If you do wish to arm the alarm in instant mode proceed as follows:
1) Key in your 4-digit security code
2) Press key 1 (after the fifteen second exit delay the alarm will be armed) during the exit delay the alarm will bleep and the
status LED will flash.
To arm the alarm in entry delay mode proceed as follows:
1) Key in your 4-digit security code
2) Press key 2 (after the fifteen-second-exit delay the alarm will be armed) during the exit delay the alarm will bleep and the
status LED will flash.
To disarm the alarm proceed as follows:
1) Key in your 4-digit security code
2) Press key 4.
·
If the alarm is triggered the siren will sound for thirty seconds, be silent for ten seconds, repeated for ten cycles or until the
alarm is disarmed.
·
If a code entry error is made the Low Battery LED will flash and the alarm will emit three beeps. If three consecutive code
entry errors are made the keypad will be disabled for thirty seconds or until the siren sequence has ended.
OTHER FEATURES
1) The default keypad tone is on. To turn the keypad tone off, or back on, key in your 4-digit security code then press key 8.
2) The alarm can be used as a door chime. This function will only work when the alarm is disarmed. To turn the chime on key in
your 4-digit security code then press key 3. To turn the chime off key in your 4-digit security code then press key 4.
In chime mode the alarm will emit a two-tone sound when a TITAN transmitter triggers the alarm including the TITAN Bell Push
Transmitter.
TROUBLE SHOOTING
Unit will not learn codes or does not respond to TITAN
transmitters:
l
Check polarity of batteries.
l
Batteries low or flat.
l
Ensure transmitter is working and within range.
Unit siren volume weak:
l
Batteries low.
Environmental Concerns:
Please DO NOT dispose of electrical appliances as unsorted waste, use the recycling facilities provided by your local
authorities.
Please DO NOT dispose of packaging as unsorted waste, use the recycling facilities provided by your local authorities.
Page 2 of 2
SPECIFICATIONS
Power Requirement
4 x 1.5v AA Batteries
Receiver Frequency
433MHz
Mounting Height
Recommended 1.5 - 2.0m
Solid Wall Mount
Keypad
10 digits and #
Ý
Operating Mode
Chime: 2 tone for 2 cycles
Alarm: Siren 30 seconds, silent
10 seconds, 10 cycles
Warm Up Time
Approximately 10 seconds
Index of Protection
IP21 Indoor Use Only
Specifications subject to change without notice.
