Titan SF75, Safety And Operating Manual

Page: 12 / 20

Fig 2
If the paint takes longer than the recommended
time to empty, then further thinning is required.
Mix in a small quantity of the appropriate
thinner and use the viscosity test until the
correct thickness is achieved.
2. FILLING AND ATTACHING THE
CONTAINER
(see fig2 and fig3)
(a) Remove the container from the machine.
(b) Before each use add a few drops of oil to
holes 1 and 2. Press the suction tube firmly into
the hole (2).
(c) Fill the container with paint of the correct
viscosity and place it onto the machine, securely
tighten the container.
3. ADJUSTING THE SPRAY PATTERN
(see
fig4)
Note: Never use the machine without any
liquid in the container. The filter should
always stay below the liquid surface.
The sprayed capacity can he adjusted using the
adjusting knob. Before starting the operation,
make sure the locknut and the nozzle are
tightened securely. Fill the paint container with
the correctly thinned and strained paint. Aim
the spray gun at a piece of scrap material and
operate the trigger switch until paint is spraying.
Adjust the adjusting knob until the best spray
pattern is reached. Rotating the adjusting knob
clockwise reduces the output and anti-clockwise
increase the output. A poor spray pattern will
concentrate the paint in the centre of the spray
and give a blotchy finish. A good spray pattern
will give even distribution of paint throughout
the pattern.
Fig 3
Fig 4