Titan SF210JSL, Safety And Operating Manual, Page: 21 / 28

8
”
Laser sLiding Compound mitre saw sF210JsL
and the 90
O
perpendicular setting of the tilt be
checked, as these positions may have moved in
transit.
To confirm the 0
O
rotary table setting, set the
rotary table at 0
O
and tighten the rotary table lock
handle. Check that the angle between the straight
guide and the blade is 90
O
using a try square (A,
not supplied). If the angle requires adjustment,
loosen four straight guide clamp screws (as shown
in Fig25) and align the straight guide against the
try square. Re-tighten the clamp screws.
Similarly, check that the angle of the blade to the
face of table in 90
O
. See Fig26. If it is not vertical,
use a suitable slotted screwdriver, loosen nut
on 90
O
setscrew, (shown in Fig20), incline head
slightly and then wheel the screw to adjust.
The 45
O
bevel can also be adjusted with a 45
O
set
square or mitre gauge, (B in Fig27, not supplied),
to check the 45
O
angle. If required, adjust the 45
O
set screw (Fig27) to set the correct stop position,
then tighten the lock nut.
Note: The position of bevel scale pointer may
have moved in transit or after use. Use screwdriver
to adjust it if necessary.
2.
CHANGING THE SAW bLADE
Disconnect the saw from the power supply.
Remove the screw on lower left of guard
mounting plate and lose the screw on upper right
of mounting plate, do not unscrew the screw
completely; Then swing the retractable safety
guard to the rear, press the spindle lock button
rotate the blade until it is locked; Then loosen and
remove the blade securing bolt, and outer flange
with the socket wrench provided. See Fig28, 29&
30.
Fig 27
Fig 26
Straight
guide
clamp
screws
Fig 28
Mounting
plate
Fig 29
Loosen
slightly