3
ASSEMBLY INSTRUCTIONS
STEP 1:
The
SUPPORTING POLE (2)
has one hole on
one end, and the other end has two holes; assemble
the
TUBE CLAMP (3)
on the
SUPPORTING POLE
,
which has only one hole by using one
SCREW (5)
and
one
NUT (4).
NOTE: Both Tabs of the clamp must be on the same side
of the tube.
DO NOT FASTEN THE SCREW/NUT.
STEP 2:
Assemble the other end of the
SUPPORTING
POLE
on the back of the
TABLE (1)
by using two
SCREW (5)
and two
NUT (4)
.
STEP 3:
Remove the lid of your kettle, place
TABLE (1)
on your kettle by snapping the two clips onto the
edge of your kettle.
STEP 4:
Assemble
TUBE CLAMP (3)
on either back leg
above the wheel of your kettle. Put one
SCREW (5)
and one
NUT (4)
on the other hole of the
TUBE
CLAMP
, make sure the
TABLE
is even and horizontal,
then fasten both
SCREWS
and
NUTS
on the
TUBE
CLAMP
.
NOTE: Both Tabs of the clamp must be on the same side
of the tube.
STEP 5:
Place the three-piece
HOOKS (6)
in pre-drilled
mounting holes.
