TISO
TRACK-AS-YOU-GO PRO
Easy Install Guide (ASDA SIM)
This guide is designed to show you the common install procedures, and set up on the
website. For more complex installations please consult the hardware guide.
1.
Remove the plastic cap at the connectors end of the tracker unit.
If you push the antennae connectors on the opposite end and the circuit board
should slide out. You don’t need to slide it out all of the way, just enough to put
your SIM card in.
2.
I
nsert your SIM card into slot on the board, so the metal contacts on the SIM
are facing down, the angled corner of the SIM should be facing the connectors
end of the unit.
3.
Make sure that the battery connector is on the top of the board, then start to
slide the circuit board back into the case. You then need to connect the battery to
the power pins, which are between the two black connectors at the front of the
board. The red wire should go next to the smaller 4 way connector
Replace the circuit board into the box and secure the plastic end cap with the
additional screws provided in the box
4.
Connect the dual antenna leads to the rear of the unit.
With the device positioned as in the picture opposite, The wire with a silver
connector and
blue
sticker marked
GSM
should go on to the
left
hand side, and
the one with a gold connector and
orange
sticker marked
GPS
should go on the
one in the
middle
of the unit.
