3
These three controls are original from the TR-909. Tone and Snappy both control
the noise section of the snare drum. Tone sets the length of the noise and Snappy
sets the gain of the noise. The Snappy in the SD909 can go higher then the one
in the TR-909, so if you are after an exact 909 sound then watch the levels and
balance so is does not override the VCOs ‘kick’ sound.
Tune controls the internal VCOs pitch, and a CV input is provided for even more
experiments.
The TR909 noise explained:
Inside the SD909 is the original binary noise generator of the TR-909. In the TR-909
this noise generator was fixed, but in the SD909 we added CV and a knob which
let us control the clocking frequency of the noise. The noise feeds into the snare
drum sound but is also available in its pure unfiltered form at the NOISE OUT
jack. Coupled with envelope generators, filters and VCAs you can shape new
drum sounds using the NOISE as the source.
When lowering the NOISE frequency down to modify the SD909 snare drum the
sound will become more and more metallic, and the clocking noise will gradually
appear, this is not a defect, but the nature of this circuit.
Accent Explained:
The accent input can be driven by either a gate/trigger or CV signal.
When the accent input is not in use, the incoming gate input is routed
(normalized) to both the accent input and the gate input.
Connecting a gate or CV signal into the accent input will break the internal routing
mentioned above and will allow for independent control over accent regardless
of the incoming gate signal. In this case as long as there is no accent signal
present, the drum sound will be set to the interally set minimum accent level,
and once the accent input receives a gate or CV signal, the drum sound will get
louder in proportion to the accent level set by the accent knob. In short: the
higher the knob setting, the larger the difference will be in gain levels between
the accented notes and the un-accented notes. Using CV allows for even greater
variations. As mentioned earlier, please note that in the 909 snare the accent
affects the balance between the noise and ‘kick’ sounds that make up the
snare drum.
Tone Tune and Snappy explained: