Connecting Modules to Power
When shipped from the factory the module will have the power ribbon cable correctly
connected to the module. If the cable is removed at some point, use the following
instructions to reconnect the module to power:
1
Locate the power header on the rear of the module circuit board. It may have one
or two rows of pins and and have 5 or 8 pins per row. Make sure the header is not
labeled SyncBus.
2
Check the circuit board near the bottom pin of the power header for printing that
says ‘Red Line’ or ‘-12V’. This may be faintly printed so use good lighting and a
magnifier to locate it.
3
Plug the cable into the power header with the red line on the cable matching with
the printing. Double check that all of the pins are covered by the connector!
Here are the three types of power connectors available on Tiptop Audio modules:
MISO SPECS:
Size: 10HP – Depth: 42mm
Power Consumption: +12V 55ma / -12V 55ma
Input voltage range: +/-10V
Output voltage range: +/-10V
Crossfade CV voltage range: +/-10V
Max offset: +/-10V
http://tiptopaudio.com/miso/
Connect using Tiptop
10 pin to 16 pin power cable
Connect using Tiptop
16 pin to 16 pin power cable
Connect using Tiptop
16 pin to 16 pin power cable
Connect either rwo
