340 West Broad Street, Burlington NJ 08016
Tel: 1
‐
800
‐
347
‐
8367 Tel: 1
‐
609
‐
239
‐
1900 Fax: 1609
‐
239
‐
1911
Web: www.tiptemp.com
and products become the property of TIP TEMPerature Products and must be returned to TIP
TEMPerature Products. Replacement parts and products assume the remaining original warranty, or
ninety (90) days, whichever is longer. TIP TEMPerature Products will pay all expenses for labor
and materials for all repairs covered by this warranty. If necessary repairs are not covered by this
warranty, or if a product is examined which is not in need of repair, you will be charged for the repairs
or examination. The owner must pay any shipping charges incurred in getting your product to a TIP
TEMPerature Products authorized service center. TIP TEMPerature Products will pay ground return
shipping charges to the owner of the product to a USA address only.
Note:
The LED turns ON briefly after changing batteries. However, the LED turns OFF if there is no
Gateway connected. The previously stored information in the TX60U-IT sensor will not be affected or
cancelled while you change the batteries.
MOUNTING
THE TX60U-IT TEMPERATURE & HUMIDITY SENSOR
The TX60U-IT sensor can be mounted onto a wall with the use of screws
MOUNTING WITH SCREWS
Your TIPTEMP warranty covers all defects in material and workmanship with the following specified
exceptions: (1) damage caused by accident, unreasonable use or neglect (including the lack of
reasonable and necessary maintenance); (2) damage occurring during shipment (claims must be
presented to the carrier); (3) damage to, or deterioration of, any accessory or
decorative surface; (4) damage resulting from failure to follow instructions contained in your owner’s
manual; (5) damage resulting from the performance of repairs or alterations by someone other than
an authorized TIP TEMPerature Products service center; (6) units used for other than home use (7)
applications and uses that this product was not intended or (8) the products inability to receive a
signal due to any source of interference.. This warranty covers only actual defects within the product
itself, and does not cover the cost of installation or removal from a fixed installation, normal set-up or
adjustments, claims based on misrepresentation by the seller or performance variations resulting
from installation-related circumstances.
1. Remove the mounting bracket from the TX60U-IT sensor.
2. Place the mounting bracket over the desired location.
3. Mark the mounting surface with a pencil through the two screw holes of the bracket,.
4. Screw the mounting bracket onto the mounting surface. Ensure that the screws are tight against
the bracket.
5. Insert the TX60U-IT sensor into the bracket.
