8
emax-usa.com
Operation
Power
Power on and off by holding the power button for 2 seconds. The center light will turn
green when on.
Binding
The radio comes already bound to tinyhawk II
Freestyle
in the ready to fly kit. If
binding is necessary follow these steps:
1. Put tinyhawk II
Freestyle
into binding mode by pressing and holding the bind
button while powering on tinyhawk II
Freestyle
. A green light will power on
tinyhawk II
Freestyle
flight controller indicating in bind mode.
2. Put the radio into bind mode by first powering on the radio and then press
and hold both the throttle trim down and pitch trim down buttons for 2
seconds until a red light turns on next to the green light around the power
button. Release the buttons and the red and green lights will flash indicating
the radio is in binding mode.
3. Monitor the tinyhawk II
Freestyle
flight controller; a red light will flash on the
board indicating when binding has been completed.
4. Take the radio out of binding mode by pressing and holding the throttle trim
down and pitch trim down buttons for 2 seconds until the red lights turn off.
5. Unplug tinyhawk II
Freestyle
battery to power it down to take it out of binding
mode.
6. Tinyhawk II
Freestyle
and radio will not be bound.
Trim
There are trim buttons for each axis on each gimbal. Each trim adjustment will beep
the radio and a longer beep will sound for center trim. Adjust roll and pitch trim when
hovering to achieve a stable hover with no gimbal input.
Gimbal Calibration
The radio comes pre-calibrated; however, recalibrating can help troubleshoot some
problems.
1. With the radio off, pull the right gimbal to the lower right corner and then
power on.
2. Release the right gimbal to its center position and red lights will flash around
the power button indicating in calibration mode.
3. Use the right gimbal and pitch forward to the maximum pitch forward point
then press the respective trim button (pitch positive trim) setting the maximum
point for the pitch axis.
4. Repeat for the right gimbal most minimum position and press the respective
trim button (pitch negative trim) to set the minum.
5. Repeat step 3 and 4 for each axis on both gimbals.
