Web: www.tinker-rasor.com
E-mail: [email protected]
Page
5
of
6
CORROSION
MITIGATION
INSTRUMENTATION
P.
O.
B
OX
1667
S
AN
B
ERNARDINO
,
C
A
92402
T
EL
:
(909)
890-0700
F
AX
:
(909)
890-0736
P
RODUCT
I
NSTRUCTIONS
ADJUSTMENT OF SIGNAL SYSTEM
Model M/1 Holiday Detector sensitivity may be verified by simply depressing push buttons on the
front of the instrument. The instrument is Factory set for use on steel structures.
For use on steel structures, depress
BLACK
button (80K); Detector should signal and
LED
will
light if detector is in calibration.
Depress
RED
button (90K): Detector should
NOT
signal and
LED
will
NOT
light if detector is in
calibration.
If the detector signals when both the
BLACK
button (80K)
and the
RED
button (90K) is depressed, the unit is set for
concrete structures. The adjustment is a small jumper setting
on the main circuit board. This jumper is accessible by
removing the Red case. See Figure 4. Care must be used
when separating the Red and Black halves of the case, as the
Battery holder is mounted in the Red case and wired to the
main board mounted in the Black case.
If the BLACK button (80K) fails to signal, the instrument is not
in calibration and should be sent for Factory calibration.
ACCESSORIES
All accessories included with the instrument (page 1 list) are available for purchase, including
additional sponges. Sponge electrodes are available in standard size, as included with new
instruments, or as custom size widths, or as disks for internal pipeline coatings. Contact T&R for
details.
The M/1 can use optional headphones for loud/noisy environments. Headphones are available for
purchase from Tinker & Rasor or many standard headphones with 3.5mm jack will work with the
M/1. Older versions of the M/1 accepted a ¼” stereo jack headphone.
FACTORY REPAIRS
Holiday Detectors returned to the factory for repairs should be sent TRANSPORTATION PREPAID.
In most cases the detector can be repaired and returned the same day it is received at the factory.
WHEN ORDERING PARTS FOR YOUR DETECTOR OR REQUESTING FURTHER
INFORMATION ALWAYS GIVE THE DETECTOR’S SERIAL NUMBER.
Visit
www.tinker-rasor.com/repair
for shipping information and the Repair Form
103-278
Figure 4
