Automatic regulation of burning REG110
6
4
INDICATION OF THE PROCESES OF THE AUTOMATIC REGULATION OF
BURNING
•
The process of the active automatic control
o
„
Indication of the automatic control mode
“
(see Chapter- 3.1 Main screen) flashes in
regular intervals.
•
Heating proces
o
„Indication of the automatic control mode” flashes along with the displayed figure on
the screen.
•
Switching into the idle state of the automatic control
o
Only the
„Indication of the automatic control mode” flashes on the display. Other
figures are not displayed
•
The process of ventilation the combustion products (only in case if it was selected by a
technician)
o
The
„
Indication of the automa
tic control mode” is displayed continuously
5
CONTROL PROCEDURE OF THE AUTOMATIC REGULATION OF BURNING
5.1
Regulation start
A new process of the automatic regulation of burning is commenced by the automatic regulation
start. Firstly, the EAI damper is opened, which secures the maximum air inlet into the fire chamber.
Every start is confirmed by sound signal.
The regulation start is done either automatically or manually:
•
Automatically
o
if the stove door switch is installed
o
in case the software door switch
–
SDS is active (see Chapter 3.1)
•
Manually
o
if the stove door switch is not installed and the SDS switch is not active, the
regulation start is to be commenced manually by pressing the button
“R”
for the period of
1
sec.
The regulation start has to be performed at every lighting up and at every stoking!
5.2
Refill the Wood
If it is necessary to add more wood, it is signalized by the sound signal and by flashing figure on the
display.
It is necessary to abide by the producer’s recommendation concernin
g the amount and quality of
wood.
6
SAFETY INSTRUCTIONS
6.1
Procedure in case of power outage
In case of power outage at any time during the automatic control, it is not necessary to restrict or
stop the ongoing heating. Although, it is necessary to take in mind, that the EAI damper remained in
the position in which it was before the power outage.
In case it is necessary to add more wood, it is
necessary
to open the EAI manually into the position
100% (see Chapter 5.1.1).
