SETTING THE CLOCK MANUALLY
SET
Back of Clock
“Set” to confirm
manual settings
Down
Arrow
SET
Up
Arrow
5
4
The wireless temperature sensor MUST BE PLACED OUTDOORS to capture and relay the
outdoor temperature to the clock display unit. You may place your wireless temperature
sensor outside up to 100 feet (30m) from the clock, as shown.
Placement of the Clock:
Place the clock in an area free of dirt and dust. To help ensure an accurate
indoor temperature measurement, be sure to place the main unit out of
direct sunlight, and away from any heat sources or vents in your home.
This clock may be hung on a wall using the integrated wall-hanging hole,
or you may place the unit on a tabletop or other flat surface using the
swing-out stands.
Placement of the Outdoor Sensor:
The sensor is water resistant and is designed
for outdoor use. However, to extend the life
of the product, place it in an area protected
from harsh weather elements. To ensure an
accurate temperature reading, be sure the
sensor is out of direct sunlight and away from
any heat sources.
164 Feet Maximum
(50 meters)
100’ Feet
a) Press and
HOLD
the SET button until you see the selection of seven time zones
b) Press the UP (
s
) ARROW
repeatedly
until you reach your time zone,
then press
SET.
a) Press the UP (
s
) ARROW to turn
DST
(Daylight Saving Time) function on or off.
Press “SET” to confirm.
b) The
HOUR
will flash
c) The
MINUTE
will flash
d) The
YEAR
will flash
e) The
MONTH
will flash
f) The
DATE
will flash
e) The
°F
will flash
Press “SET”
to confirm
Press “SET”
to confirm
Press “SET”
to confirm
Press “SET”
to confirm
Press “SET”
to confirm
Press “SET”
to confirm
Press the UP (
s
) ARROW
repeatedly,
until the correct hour (AM or PM) is
displayed.
Press the UP (
s
) ARROW
repeatedly,
until the correct minute is displayed.
Press the UP (
s
) ARROW
repeatedly,
until the correct year is displayed.
Press the UP (
s
) ARROW
repeatedly,
until the correct month is displayed.
Press the UP (
s
) ARROW
repeatedly,
until the correct date is displayed.
Press the UP (
s
) ARROW to change
between
°F and °C.
Press the UP (
s
) ARROW to or DOWN (
t
) ARROW buttons
to turn OFF
Atomic signal
. This will stop the clock from searching for the Atomic radio
signal, and allow you to set the clock manually.
NOTE: You do NOT need to turn off the atomic clock to set the time manually. Once the clock receives the signal, it will adjust the
clock accordingl. However, you may choose to deactivate the atomic clock feature completely if you prefer to manually control
the clock or if you live in a remote area that does not readily receive the atomic signal. As long as the atomic clock is ON, it will
automaticlly adjust itself to the correct time, overriding your manual setting.
1) SETTING YOUR TIME ZONE
3) SETTING THE CLOCK & CALENDAR
2) TURNING ATOMIC CLOCK FEATURE ON/OFF
DAY OF THE WEEK AND MOON PHASE WILL UPDATE AUTOMATICALLY AS YOU SET THE DATE
The main unit has signal reception icons in the outdoor temperature display area and
near the clock display. For the first installation, the bars running to indicate the signal
reception. Once received the signal, the temperature will be displayed. If there are a
low number of “bars” present, you may experience the signal antenna. “ “ flashing to
indicate no outdoor temperature receive or inaccuracy. In either case, you may need
to relocate one or both of the units. If most or all 4 of the “bars” are present, wireless
reception is good and no action is required.
Wireless Signal Reception Icons
Strong
Reception
NO
Reception
