OPERATION INSTRUCTIONS
·
The PROFILE 200 RGBW is an LED wash light for on-site decoration purpose.
·
Don't turn on the fixture if it's been through severe temperature difference like after transportation
because it might damage the light due to the environment changes. So make sure to operate the
fixture until it is in normal temperature.
·
This light should be keep away from strong shaking during any transportation or movement.
·
Don't pull up the light by only the head, or it might cause damages to the mechanical parts.
·
Don't expose the fixture in overheat, moisture or environment with too much dust when installing
it. And don't lay any power cables on the floor. Or it might cause electronic shock to the people.
·
Make sure the installation place is in good safety condition before installing the fixture.
·
Make sure to put the safety chain and check whether the screws are screwed properly when
installing the fixture.
·
Make sure the lens are in good condition. It's recommended to replace the units if there are any
damages or severe scratch.
·
Make sure the fixture is operated by qualified personnel who knows the fixture before using.
·
Keep the original packages if any second shipment is needed.
·
Don't try to change the fixtures without any instruction by the manufacturer or the appointed
repairing agencies.
·
It is not in warranty range if there are any malfunctions from not following the user manual to
operate or any illegal operation, like shock short circuit, electronic shock, lamp broke, etc.
INSTALLATIONS
For added protection mount the fixtures in areas outside walking paths, seating areas, or in areas
were the fixture might be reached by unauthorized personnel.
Before mounting the fixture to any surface, make sure that the installation area can hold a
minimum point load of 10 times the device's weight.
Fixture installation must always be secured with a secondary safety attachment, such as an
appropriate safety cable.
Never stand directly below the device when mounting, removing, or servicing the fixture.
From a ceiling, or set on a flat level surface (see illustration below). Be sure this fixture is kept at
least 0.5m (1.5 ft) away from any flammable materials (decoration etc.).
7
8
Summary of Contents for PROFILE 200 RGBW
Page 1: ...V200 Projector User Manual...
