5
. Press ‘SET’ key once the
symbol flashes then press ‘+’ or ‘
−
’ keys to set ‘Comfort’
temp from 10
°
C up to 30
°
C
6
. Press the ”SET” button and the
symbol flashes and set the ‘Set Back’ temp in the same
way.
7
. Once again press the ‘SET’ key and the
symbol is displayed.
8
. Press ‘+’ or ‘
−
’ keys to set the floor limiter temperature from 20
°
C up to 30
°
C.
(The floor limiter should not be set higher than 30
°
C.)
9
. Press ‘SET’ key to exit. The control will then display the room temperature.
The control will revert to
normal display after about 15 seconds, so if it goes back to showing
time whilst you are setting it up just start again by pressing the “PROG” button and if you
have already programmed the time simply press the “SET” button to skip to the next function
to be set. This also applies if you just wish to change one function i.e. if you wish to change
the “Comfort” temperature press “PROG” button and then “SET” button twice.
Bathrooms
This control should not be sited in a bathroom, so when using the control to regulate a
heating mat situated in a bathroom it should be positioned outside the bathroom (not in an
airing cupboard). The programs should be set as above to your own requirements but the
temperatures should be set as follows -
Comfort temperature at about 25
ο
C (in excess of the ambient temperature
where the control is sited).
Set back temperature at about 16
ο
C.
The maximum floor temperature, use this to control the temperature of the
bathroom floor, suggest trying 24
ο
C and then altering until you are satisfied with the floor
temperature.
Manual Temperature Setting
A. Temporary Temperature Override.
1
. Press ‘+’ or ‘
−
’. The
indicator and the temperature will flash.
2
. Press the ‘+’ or ‘
−
’ key to the desired temperature.
3
. Press the ‘Set’ key once to confirm. The
will flash every 3 seconds. It will stay in the
temporary setting until the mode next switches from comfort to setback or vice versa.
4
. To exit the temporary setting at any time, just press ‘SET’.
