6
9
10
1
1
1
Ref.
Qty
Ref. Description
5
Qty
1
2
3
1
1
1
Parts Checklist
Description
4
1
1
Headboard
Footboard
Side Rail - LH
Side Rail - RH
Lift Mechanism - LH
Lift Mechanism - RH
Gas Lift Pistons
Angle Corner Brackets
r
e
v
o
C
e
s
a
B
c
ir
b
a
F
Fabric Strap
7
8
2
2
15
2/3
14
11
12
13
2
1
1
1
Cross Rail for Metal Slat Frame - Headend
Cross Rail for Metal Slat Frame - Footend
Side Rail for Metal Slat Frame
Bentwood Slats
16
Fittings Checklist
Care & Maintenance
General Hints & Tips
Please
retain
your
assembly instruction and
tools provided for future use.
Periodically check that all bolts are still tight.
Approximate time to
assemble this product
In the unlikely event of missing or damaged parts,
please contact your retailer. Please have this guide at
hand quoting the part code reference numbers shown
when requesting spare or replacement parts.
Qty
Code
Description
A
C
x16
D
Qty
Code Description
B
HARDWARE NEEDED FOR BED ASSEMBLY
x12
x1
H
E
F
G
x1
Flat washers for M8 bolts
Big head bolts (M8x45mm) for
assembling metal slat frame rails
and fitting assembled metal slat
frame to lift mechanisms (5&6).
Also for fitting ‘U’ shaped cross
bar (12) to side rails (3&4).
Big head bolts (M8x30mm) for
fitting gas lift mechanisms (5&6)
to Side Rails and fitting Side
Rails (3&4) to headboard and
footboard (1&2)
Big Head Bolts (M8x16mm) for
fitting frame support brackets (11)
and corner brackets (8) to
headboard and footboard (1&2)
Allen key for M8 bolts
Spanner for M8 nuts
x16
x14
Single
Small Double,
Double & King
Small Double,
Double & King
Nuts for M8 bolts
14/28/30
Mattress Stopper
17
1/2
Single Plastic Caps
18
28/30
Double Plastic Caps
19
14/15
x16
x14
Single
x12
x10
Single
x8
Plastic spacers for lift
mechanisms (5&6)
Frame Support Bracket
‘U’ Shape Cross Bar
NOTE:
Before moving the slat frame, place the mattress on the slats. Without a mattress in place, the
speed of movement is quick and may cause injury so great care is needed.
Carefully lower the frame with the fabric hand-strap (10) ensuring the frame sides are aligned with the side
panels; there should be an even gap on each side.
If not aligned, check bed is still square (see Stage 4) and if it is, but gaps are still not even, re-align.
Depending on the weight of the mattress, the rising speed will vary so be careful until you get used to the
speed.
Always use the hand-strap to lift or lower the frame - keep fingers well away from the moving parts.
When fully assembled and with the mattress in position, please raise & lower the ottoman
4/5 times to ensure the gas pistons are fully lubricated.
Page 2 of 8
Two person
assembly
Warnings
Small Double,
Double & King
Single/Small Double, Double or King
Single/Small Double, Double or King
Single/Small Double or Double/King
Single, Small Double or Double/King
Small Double or Double/King
