4. Push up on the bottom of the ejector and holding
arm (B5) just far enough to insert the tap wire under
the holding arm. (
Fig. 5)
Insert the tap wire into the tap wire hole in the con-
nector bottom.
(Fig. 6)
5. Once the tap wire is
fi
rmly inserted into the con-
nector bottom release the ejector and holding arm
(B5) so that the holding arm is applying pressure
onto the tap wire.
(Fig. 7)
6. Hook onto the tracer wire through the keyhole.
Pull up gently applying tension on the existing trace
wire. This will locate the wire into the connector.
(Fig. 8)
7. Push the handle (A1) all the way forward to
crimp.
(Fig. 8)
8. Pull the handle (A1) all the way back to eject the
connector from the tool.
(Fig. 8)
Fig. 5
Fig. 6
Fig. 7
Fig. 8
© 2008 Timberline Tool All Rights Reserved.
6
