Timberk RE8 Series, Instruction Manual

Page: 13 / 16

IM2020
13
3. Temperature setting
3.1. The room temperature can be set in the range from 0 to +40 °C.
3.2. In heating mode, turn the thermostat knob fully clockwise, if the room temperature is lower than the set
temperature, the heating elements will turn on. When the room temperature reaches the desired level, turn
the thermostat knob counterclockwise until the heating elements turn off.
Now the thermostat will maintain the set temperature automatically, by turning on and off the heating
elements, the motor will work.
ATTENTION!
1. The first time the device is turned on, a specific odor and smoke may appear (oil is burned from the
surface of the heating elements). It is recommended to turn on the curtain in heating mode for 10 - 20 minutes
in a well - ventilated area.
2. After transportation or storage of the device at below 0
0
C temperatures, it is necessary to store it in the
room where operation is supposed to be, without turning the device on for at least 2 hours. After prolonged
storage or break in use, do not turn on the device in high heating power mode.
ATTENTION!
Frequent triggering of the emergency shutdown device is not normal mode of operation of the device. In this
case make sure that the device is really defective and contact an authorized service center.
4. Turning off
Turn the thermostat knob fully counterclockwise and let the device run in ventilation mode for 3 minutes to
cool the heating elements, then set the operating mode selection
knob to position.
ATTENTION!
In order to increase the life time of the device, it is recommended to follow the above mentioned instructions
for turning off the device. Turning off the device without cooling the heating elements first can cause
overheating and premature failure of the heating elements.
9. MAINTANANCE
The electric fan heater does not require any consumables for maintenance. In normal use, it does not require
maintenance, but only dusting the fan grilles and monitoring performance. The serviceability of the device is
determined by external inspection, then by turning on and checking the heating of the air flow.
When cleaning the device, do not use abrasive cleaners, as well as products containing alcohol and solvent.
This may damage the coating of the body or the body itself. Use a piece of cloth dampened with water. If the
contamination is heavy, you can use a cloth soaked in soapy water. Before use, the device must be dry.
WARNING:
Before cleaning the device, it must be turned off and disconnected from the power supply.
10. WIRING DIAGRAM
Fig. 3