Page of 10
7
CLAMPING THE SCREW SET UP
1. Before grinding begins, the chain should be secured between the guides. The tooth to be
sharpened first should be placed against the stop. Watch that the sharpening angle corresponds to
the guide position.
2. Set the guides to the chain width using the set screw (A) so that it is firmly fixed in the clamp screw
by rotating the lever control. (B)
3. Set the backstop by adjusting the set screw.(D)
4. Set the top plate angle by adjusting the set screw corresponding to the readout scale. The top
angle should be set up by adjusting the set screw. (E)
OPERATION :
1. With all adjustments set, lower the grinding wheel to the tooth. The grinding depth may be set by
set screw (F).
2. With lever control loose (B), adjust the set screw until the grinding wheel touches the tooth. During
the procedure, pull the chain through the guide (C) carefully.