23
EN
THE DEVICE MAY GENERATE OXYGEN ALSO WHEN THE
WATER TANK IS EMPTY.
POINT THE REMOTE CONTROL TOWARDS THE REMOTE
CONTROL RECEIVER.
p o s i t i o n ; t h e d i s p l a y s h o w s :
„ H E L L O “ , w h i c h m e a n s t h e
device is working correctly. After
4 s the display shows num be rs
re presenting flow rate , ox ygen
concentration and elapsed time
and the time setting field („--“),
and then the device shall switch to
normal operation mode.
5.2 Absorption of oxygen
P re s sin g th e „ FLOW R AT E ”
button on device control panel
sets the flow rate as per oxygen
demand. Display shows flow
rate and oxygen concentration
readings.
T h e n c o n n e c t c a n n u l a s t o
oxygen outlet and place their
other ends in patient’s nose.
5.3 Setting time
The device is fitted with time
programmer, which can be set in
the range 10−120 min.
Symbol „--“ on display means
continuous operation mode.
Each pressing of „+“ extends
the operation time by 10 min;
pressing and holding for more
than 1.5 s extends operation time
continuously.
Each pressing of „-“ reduces
the operation time by 10 min;
pressing and holding for more
than 1.5 s reduces operation time
continuously.
T h e o x y g e n c o n c e n t r a t o r
will automatically shut down
meanwhile LCD shows “0” when
time runs out.
5.4 Anion generation functionality
Anion generation functionality
is activated by pressing the
„ A N I O N “ b u t to n o n d ev i c e
control panel.
5.5 Switching off
Remove nose cannulas from
oxygen outlet, turn the power
switch on device control panel
off and then disconnect from
power supply.
5.6 IR remote control system
The device can be operated
re m ote ly, u si n g th e re m ote
control device, with controls
duplicating those of control
panel buttons.