Page 4
www.kpa-solutions.com
Please make sure that there are no obvious transport damages. Should you notice any damages
on the A/C connection cable or on the casing, do not take the device into operation and immediately
consult your local dealer.
This device falls under protection-class I. The power plug must only be plugged into a protection
class I outlet. The voltage and frequency must exactly be the same as stated on the device. Wrong
voltages or power outlets can lead to the destruction of the device and to mortal electrical shock.
Always plug in the power plug least. The power plug must always be inserted without force. Make
sure that the plug is tightly connected with the outlet.
Never let the power cord come into contact with other cables! Handle the power cord and all con-
nections with the mains with particular caution! Never touch them with wet hands, as this could lead
to mortal electrical shock.
Never modify, bend, strain mechanically, put pressure on, pull or heat up the power cord. Never
operate next to sources of heat or cold. Disregard can lead to power cord damages, fire or mortal
electrical shock.
The cable insert or the female part in the device must never be strained. There must always be suf-
ficient cable to the device. Otherwise, the cable may be damaged which may lead to mortal damage.
Make sure that the power cord is never crimped or damaged by sharp edges. Check the device and
the power cord from time to time.
If extension cords are used, make sure that the core diameter is sufficient for the required power
consumption of the device. All warnings concerning the power cords are also valid for possible ex-
tension cords.
Always disconnect from the mains, when the device is not in use or before cleaning it. Only handle
the power cord by the plug. Never pull out the plug by tugging the power-cord. Otherwise, the cable
or plug can be damaged leading to mortal electrical shock. If the power plug or the power switch is
not accessible, the device must be disconnected via the mains.
If the power plug or the device is dusty, the device must be taken out of operation, disconnected and
then be cleaned with a dry cloth. Dust can reduce the insulation which may lead to mortal electrical
shock. More severe dirt in and at the device should only be removed by a specialist.
There must never enter any liquid into power outlets, extension cords or any holes in the housing of
the device. If you suppose that also a minimal amount of liquid may have entered the device, it must
immediately be disconnected. This is also valid, if the device was exposed to high humidity. Also if
the device is still running, the device must be checked by a specialist if the liquid has reduced any
insulation. Reduced insulation can cause mortal electrical shock.
There must never be any objects entering into the device. This is especially valid for metal parts. If
any metal parts like staples or coarse metal chips enter into the device, the device must be taken
out of operation and disconnected immediately. Malfunction or short-circuits caused by metal parts
may cause mortal injuries.
The device and all connections have to be lightning protected.
