TILLOTSON TPP-4500DF-A, Owner'S Manual

Page: 20 / 30

LPG

Drain the fuel system completely of gasoline. You can do this by starting the engine with
gasoline, closing the gasoline valve and running the engine until dry.

Once dry, push the LPG converter button 2 times.

Close the choke.

Turn the ignition key to the ON position.

For electronic start, turn the ignition key further to the start position.

For recoil start, pull the recoil handle briskly. Do not let the handle snap back. Rather, guide
the handle gently back to the engine.

Once the engine has started and warms up, open the choke.
STOPPING THE GENERATOR
In an emergency:

To stop the engine in an emergency, move the engine switch to the OFF position.
In normal use:

Turn the AC circuit breaker to the OFF position. Disconnect DC battery charging cables.

Press the Off button on the remote control for few seconds or turn the engine switch to the
OFF position.

Turn the fuel valve lever to the OFF position.

OPERATING INSTRUCTIONS
Connections to a Building Electrical System
Connections for standby power to a building electrical system must be made by a qualified
electrician. The connection must isolate the generator power from utility power and must comply
with all applicable laws and electrical codes. A transfer switch, which isolates generator power from
utility power, is a prerequisite to a safe installation.
Improper connections to a building electrical system can allow electrical
current from the generator to back feed into the utility lines. Such back feed
may electrocute utility company workers or others who contact the lines
during a power outage, and the generator may explode, burn or cause fires
when utility power is restored. Consult the utility company or a qualified
electrician.
Ground System
The portable generators have a system ground that connects generator frame components to the
ground terminals in the AC output receptacles. The system ground is not connected to the AC neutral
wire.
20