TiLite Twist, Owner'S Manual

Page: 71 / 119

10-5
Twist Owner’s Manual
OM_TWIST_0811RevA
CHAPTER 10: WHEEL LOCKS
Figures 10-8 through 10-11 show the handle in both the engaged (locked) and disengaged (unlocked) positions.
Study the figures to determine which handle configuration will work best for you. Follow the directions below to
reconfigure your handle to the desired configuration.
Pull to Unlock
Pull to Unlock
Push to Lock
Push to Lock
Figure 10-8
Standard Handle Positions 1, 2 and 3 (Locked)
Figure 10-9
Standard Handle Positions 1, 2 and 3 (Unlocked)
Figure 10-10
Reverse Handle Positions 1, 2 and 3 (Locked)
Figure 10-11
Reverse Handle Positions 1, 2 and 3 (Unlocked)
1
2
3
1
2
3
1
2
3
1
2
3
Standard Handle Positions 1, 2, 3
The Uni-Lock ships with the handle in standard position 3. If you desire to switch to standard positions 1 or 2, follow
the procedures below.
Tools Needed:
• 1/8” Allen Wrench
• 3/8” Open End Wrench
1. As shown in Figure 10-12, the wheel lock handle attaches to the wheel lock handle base with two Allen screws.
There is only one hole in the wheel lock handle base through which to attach the upper Allen screw. There are
three holes in the wheel lock handle base through which to attach the lower Allen screw.
2. Remove the lower Allen screw and locknut that secure the wheel lock handle to the wheel lock handle base.
3. Loosen, but do not remove, the upper Allen screw that secures the wheel lock handle to the wheel lock handle
base.
4. Reposition the wheel lock handle to the desired Standard Handle Position 1, 2 or 3 (see Figures 10-8 and 10-9)
and replace the Allen screw and locknut.
5. Securely tighten both Allen screws and locknuts.