Grab Bar Screw
Configuration
Guidelines
5/32”
3/16”
1/4”
5/16”
3/8”
7/16”
1/2”
Th
in
-S
e
t
&
S
cr
e
e
d
Bui
ld
-up
Th
ickn
e
sses
1/16”
3/16”
3/8”
N/A
©2012-2016 TileWare Products. All rights reserved. PermaTile™ Fastener Patented. US Patent No. 8,161,700,
Australian Patent No. 2011205360
MORTAR BASED INSTALLATION SYSTEM – NO MASTIC
Victoria™ Series ADA 18” Grab Bars
Installation Procedures For T200-001 & T200-002
Thank you for using our
products!
TileWare Products
PO Box 793, Hickory, NC 28603
Technical Support: 828-322-9273
Email:
STEP 4 Remount Stabilizer
Warning: Do not proceed with accessory installation until thin-set mortar has
met minimum curing requirements specified by manufacturer.
Remount stabilizing bracket as shown and tighten thumb screws securely. Use
stabilizer to check if “Z” Fastener was installed level.
•
Immediately proceed to accessory mounting after grouting is completed.
•
Simply slip Bushing over hex studs. Position 6-32 threads down by placing
index finger over threaded hole while slipping onto hex stud.
•
Attach to hex studs using 10-24 stainless steel screws (see table to right).
Hand tighten with #2 Phillips head screw driver.
Technical Fact:
Mortar coverage behind drilled hole will ensure bushing can be firmly
mounted with 10-24 stainless steel screw. Screw is patched to prevent threads
from reversing or loosing.
STEP 5 Remove Stabilizer & Install Bushings
•
Each Grab Bar is drilled with 2 countersink holes that will match mounted
bushing locations. Simply slip grab bar over bushings (Note: tolerances are
precise so grab bar will feel snug when installing).
•
Simply insert 6-32 stainless steel screws through countersink holes in grab
bar and attach to threaded bushings.
•
Using a #2 Phillips-head screw driver, attach screws firmly to grab bar.
Loosely mount all screws first before firmly tightening.
Warning: Make sure screw and stud are parallel to avoid cross-threading. Turn
carefully, cross-threading will require fastener removal.
STEP 6 Mount Grab Bar
Grab Bar
quantity 1 per kit
PermaTile™ “Z” Fastener
quantity 1 per kit
Wood Screw
quantity 2 per kit
Bushing
quantity 2 per kit
Optional
Cover Washer
quantity 2 per kit
10-24
3/4” - 1 1/4” Screw
quantity 2 each per
kit
6-32
Screw
quantity 2
per kit
A220-181
A220-182
PT100-514
C200-026
C220-021
C220-023
SOLD
SEPERATELY
C200-015
&
C200-027
C200-011
OR
C200-012
Grab Bar Parts List
Not using stabilizer will result in grab bar mounting failure
Use 6-32
Screws provided
Use 10-24
screws provided
Optional
Cover Washer
to correct
drilling/notch
errors
Stabilizer used as leveling
tool & drilling template
Screws For Specific
Tile Thicknesses:
10-24 x 3/4” Screw
For Standard Build-up
10-24 x 1 1/4” Screw
For Thicker Screeds
Countersink
hole
Bushings
