62
1
Switch the chosen device (TV, satellite receiver, DVD recorder/player) that you wish to find the code for, to
ON
. When the correct code has been found the device will switch
OFF
.
2
Press and hold down the TV (TV), satellite (SAT) or DVD recorder/player (DVD) button until the red light
stays on, then release the button.
3
Press the power button once and release, this will start the auto search mode.
4
When the device switches
OFF
. Immediately press and release the device button that was initially selected
to save the code in the remote control.
When the red light switches off, all the codes have been tried and the auto search mode has been exited.
To exit the auto search mode before all the codes have been tried, press and release the device button that
was initially selected.
To learn which three digit code has been set to control the device see
Checking/Recalling the Device Code
on page 63.
Auto Search – All Brand Codes
1
Switch the chosen device (TV, satellite receiver, DVD recorder/player) that you wish to find the code for, to
ON
. When the correct code has been found the device will switch
OFF
.
2
Press and hold down the TV (TV), satellite (SAT) or DVD recorder/player (DVD) button until the red light
stays on, then release the button.
3
Press PR+ or PR- once and release. Each time PR+ or PR- is pressed a code is transmitted.
To perform a fast search, press and hold down PR+ or PR- button.
When the device switches
OFF
, release the PR+ or PR- button.
Step 4 must be executed so that the code is saved in the remote control.
4
Press and release the device button that was initially selected to save the code in the remote control.
To learn which three digit code has been set to control the device see
Checking/Recalling the Device Code
on page 63.
Manual Search - All Brand Codes
1
Press and hold down the satellite (SAT) device button until the red light stays on.
2
Enter the three digit code (192, 288 to 294 inclusive) using the number buttons 0–9.
3
As each digit is entered the red light will flash once and then remain on.
4
If the three digit code is correct the red light will go out. If the three digit code is incorrect the red light will
flash twice and then remain on.
5
Press the original device button again to exit the code entry mode.
6
Test the functionality of the control of the Sky™ satellite receiver.
Note: If a three digit code is not entered within 15 seconds the red light will flash twice and exit code
entry mode. Entering a three digit code will delete/erase the programmed buttons for that device.
Entering a Sky™ Satellite Receiver Code
