Tile Redi redi DOOR 5400 Series, Instruction Manual, Page: 7 / 9

7 RDQCI5400T-01042021
F
D
E
¼”
5
To install, find the Support Bar (F) loosen the Support Bar Screws and dry fit the Support Bar
assembly as shown. Take the Wall Mount side and make it flush against the wall. Mark the
locations of the Panel Mount and the Wall Mount, and then remove the Support Bar assembly.
Using the Wall Mount, mark the location of the pre-drilled holes on your support wall. Drill the
holes using a ¼” drill bit.
Place wall anchors into the holes and proceed to screw the Wall Mount into place.
Remove the Panel Mount and place one end of the Support Bar into the Wall Mount. Slide the
Panel Mount onto the Support Bar and position the angle adjuster so it fits onto the panel.
Finally, tighten all screws.