TECHNISONIC INDUSTRIES LIMITED
www.til.ca
TBS-150, 250, 350 Installation & Operating Instructions
TiL 92RE122 Rev L
3-16
3.5.2 Transmitter Operation
To operate the transceiver in the transmit mode, proceed as follows:
(1)
Set RF POWER switch (if applicable) to desired operating level.
(2)
Hold the microphone in one hand, with the upper edge of the microphone as close
as possible to the upper lip.
NOTE
This technique activates the noise cancelling
feature of the microphone. The microphone is
most effective when sound is ½ inch (12.7 mm)
or more away from the microphone.
(3)
Press and hold the PRESS TO TALK switch of the microphone during transmission.
(4)
Ensure that the Tx ON amber LED is ON.
(5)
Speak slowly and distinctly into the microphone using specified operating
procedures during transmission.
(6)
When message is ended, release the PRESS TO TALK switch of the microphone.
(7)
The transceiver is now operating in the receive mode.
(8)
Verify that the Tx ON amber LED is OFF.
(9)
Refer to previous paragraphs for Transceiver Operation and additional operating
modes.
