Single Phase EI Inverter
3. Connections
2.2 Inverter Installation
CAUTION - Do not perform these steps when the system is energized. Remove all sources of power during
installation.
!
3.1 Inverter Wiring
3.1.1 Connect EI Link COM cable
1.
Connect one end of the EI Link COM cable (found in EI Link Accessory kit)
to the inverter COM port as shown.
Note: It is easier to make these communication cable
connections before the EI Link is installed.
Slide the inverter onto the top bracket and lock it
with the provided M5 screw from the right side.
3.1.2 Connect CT cable
1.
Connect one end of the EI Link CT cable (found in the EI Link Accessory kit)
to the CT port on the inverter.
2. Installation
2.1 Wall Mount Bracket Assembly
1.
Assemble the brackets with provided flange nuts found in the respective
boxes. If the system has a battery, slide Lower Battery bracket onto the top
of the battery module and mark mounting holes. Remove bracket, mount
to wall, and reinstall onto the battery. If the system does not have battery,
the inverter bracket must be at least 200mm above the ground.
2.
Assemble Backbone:
•
Note: the back side of the battery base (if used) must be 20mm from
the wall.
•
Connect Inverter bracket to Bridge (found in EI Link box).
•
Connect Bridge to EI Link bracket (found in EI Link box).
•
Connect EI Link bracket to EI BMS bracket (found in EI Link box).
•
Connect BMS bracket to EI Battery bracket (found in BMS box).
3.
Connect assembled Backbone to Battery bracket previously installed on top
of Battery1. Use spirit level to verify bracket is level.
4.
Mark mounting holes on the wall.
5.
Remove Backbone and drill out wall holes.
6.
Remount Backbone to Battery bracket and secure to wall using appropriate
mounting hardware.
Note: You must install the battery base using the EI Battery QSG before attempting to install the EI Inverter.
Note: If installing the inverter without a battery, mount the inverter bracket on the wall. Proceed to Section 2.2
Note: Open each box and gather the mounting bracket pieces.
1.5 System configuration
EI Inverter
EI Inverter
bracket
Bridge
EI Link
bracket
EI BMS
bracket
EI Battery
bracket
EI Link
EI BMS
EI Battery
Quick Start Guide - TSI-3K1D/TSI-6K1D
Pg 2 of 4
PN: 002-00107-00 | REV 2.0 | Oct. 21, 2022
