Install Seat Back Cover
Use a pick or small flat screwdriver to push in the small square buttons at the base of each
headrest post. With them both pushed in, pull the headrest up and out of the seat.
Press cover under
the plastic headrest
mounts for a clean,
finished look.
Push flaps between
the seat back and
bottom. Pull tight and
fasten them to the
velcro on the back.
Make sure all latches
& release cords are
pulled out of the holdes
in the cover provided
for them.
Repeat on the other
side -
Turn cover partially
inside-out, slide over
making sure the gap is
lined up with the latch.
Press cover under
headrest mounts.
Push flaps between seat
back and bottom.
Pull tight and fasten to the
velcro at the back.
Make sure all latches &
release cords are pulled
out of the holdes in the
cover provided for them.
Tuck cover under
the plastic trim of the
handle.
Pull flaps tight and
fasten at the bottom.
2
2
11
33
44
55
66
77
88
CALL US AT 507.246.3545. FOR INSTALLATION ASSISTANCE
Fold seat back forward.
Turn cover partly
inside-out and slide
over seat wtih tag
facing the door.
Slide seat forward as
far as possible. Reach
up behind the seat,
approximately in the
center of it and pull the
release cord at the top of
the seat. This will allow
you to fold the seat back
forward.
