Tiger PDR-A30U, User Manual

Page: 13 / 88

English
12 12
4
Dispensing Hot Water
1
Press the
Unlock
key once.
Light
illuminates
2
Press the
Dispense
key.
Place a container under the spout, and press the
Dispense key.
Hot water continues to dispense while pressing the
Dispense key.
※ After checking that hot water has stopped dispensing, remove the
container from the spout
※
If the unit is unplugged, hot water cannot be dispensed.
※ When water is boiled, air pressure increases in the container so
that the water dispenser may not produce a smooth water flow
immediately after it is boiled. Release the air pressure by opening
the lid and then dispense the water. Be cautious of steam.
※ Mineral deposits can build on the wall of the inner container, mesh
filter or pump unit, causing water to not dispense.
※
If the Dispense key is not pressed for approx. 10 seconds after
dispensing hot water, the unlock lamp will be turned off and the
unit will lock automatically.
Dispense
key
• Do not dispense when water level is
at "Refill water mark". Hot water may
splash when you dispense.
• Pay close attention when dispensing
hot water so as to not spin the entire
unit around.
Caution
3
Press the
Unlock
key once.
The Dispense key. will be locked, and hot water cannot
be dispensed even if the key is pressed.
Light
turns off
■
Refill water when level becomes low.
Be sure to refill water before it reaches [Refill water mark],
and close the lid securely. (Caution for hot steam when
refilling water. See
p. 10
)
Do not leave the unit without any water
inside, this is to avoid malfunction due to
boiling without water.
Caution