Tiger JKT-W10W, Operating Instructions Manual

Page: 23 / 65

43
42
43
English
Symptom Check point Action
Reference
page
The present time, preset timer
settings, and elapsed Keep Warm
time are lost when the power plug is
disconnected.
Does “0:00” blink on the display
when the power plug is connected
again?
The lithium battery has run out.
Contact the place of purchase.
10
The lid will not close, or it opens
during cooking.
Are there any grains of rice adhering
to the upper casing, inner lid gasket,
or around the hook button?
Completely remove all remaining
rice.
14,
31-36
The lid cannot be closed. Is the inner lid attached? Attach the inner lid. 33
Nothing happens when a key is
pressed.
Is the power plug properly connected
to an outlet?
Insert the power plug fully into an
outlet.
15
Is the Keep Warm lamp on? Press the [Cancel •
取消
] key to turn
off the Keep Warm function, then try
the operation again.
15
Sparks fly from the power plug. Inserting/disconnecting the power plug may sometimes cause small electric
sparks. This is specific to the IH feature and therefore not a malfunction.
–
There is a smell of plastic. Such smells may occur when the rice cooker is first used, but they should
go away over time as the rice cooker gets used.
–
There are stripes or waves on plastic
parts.
Such stripes and waves are produced when the resin is being molded.They
do not affect the performance of the rice cooker.
–
Bubbles can be seen coming from
the steam vent of the steam cap
during cooking.
It is due to boiling and therefore not a malfunction.
–
Food adheres to the inner lid during
concurrent cooking.
When cooking with ingredients that expand during heating, such as eggs
and the like, some of that may adhere to the inner lid. If it is bothersome,
reduce the amount of the ingredients.
23
If these indications appear
Display Action
Reference
page
“Err” appears on the display and a long-
lasting or continuous beeping alarm
sounds.
If the rice cooker is placed on the carpet or where the room
temperature is high, the air inlet and outlet can be blocked, causing
the temperature inside to rise. In this case, the rice cooker may not
respond to any key operations. Resolve the problem according to the
following procedure.
(1) Disconnect the power plug.
(2) Relocate the rice cooker to where the air inlet and outlet are not
blocked and the room temperature is low.
(3) Insert the power plug into the outlet again and operate the keys.
If the rice cooker does not respond to key operations, it is a malfunction
of the rice cooker. Disconnect the power plug and contact the place of
purchase.
–
Plastic parts
Plastic parts that come into contact with heat or steam will deteriorate over time. In this case, contact the
place of purchase.
1
Connect the power plug to an
outlet.
2
Display the time setting mode.
Press the [Hour •
时
] or [Min •
分
] key to
display .
On
3
Set the present time.
Set the hour with the [Hour •
时
] key and the minute with
the [Min • 分 ] key.
Hold down the corresponding
key to change the time more rapidly.
4
Once you are finished setting
the time, press the [ ] key.
The present time is set.
will go out and “:” will blink on the display.
Blinks
Note
● The present time setting may vary about 30 to 120
seconds a month from the actual time depending
on room temperature and the conditions of use.
Setting the present time
The present time is displayed in a 24-hour format.
The time cannot be set during cooking, when the Keep Warm function is on, when the Timer function is in
use, or during reheating.
„
Example: Changing the present time from “9:30” to “9:35”