C A B I N E T S & F U R N I T U R E
5-3
residue, then clean that spot accordingly. Please note that strong chemicals, solvents, and cleaners (e.g., oven
cleaner) may damage the surface; so do not use any products not specifically designed for countertop cleaning.
The countertop may be physically damaged, too, if proper care
is not taken. Do not cut anything (e.g., vegetables, fruits)
directly on the countertop; rather, use a cutting board on top
of the countertop to provide necessary protection to the
countertop. Excessive heat may also damage the countertop;
therefore, any pots or pans taken directly from the range or
oven should not be placed directly on the countertop; rather,
use trivets or some other form of fireproof heat insulators to
hold very hot pots or pans on the countertop.
All drawers are equipped with metal slides to provide
additional load-bearing strength for the drawers and to
permit effortless opening and closing of those drawers, even
when they are fully loaded. These metal guides have a slight “locking” action, when closed. To open those
drawers, slightly lift up on the drawer handle and then pull the drawer open. To close, push the drawer closed
until it “clicks” back into place (i.e., the locking action is engaged).
As this cabinetry is typically of furniture-grade quality, any commercial furniture polish or cleaner can be used.
Do not try to soak these wooden surfaces with any water or any other liquid; be sure to wipe up spills or
residues of any fluids that contact these surfaces to preclude any staining or discoloration of the cabinet
surfaces.
Furniture
Kitchen, Dining, & Living Room Areas
On all the various floor plans of the Allegro Bus, a built-in dinette
booth (Figure 5-4) is standard; a free-standing table (Figure 5-6) is
optional. This dinette provides additional storage under the seat area
of the booth, in addition to providing additional sleeping facilities
(Figure 5-7). The sleeping area is realized by lowering the dinette-table
top and rearranging the seating cushions. Specific directions for
converting the booth dinette into a bed are as follows:
1.
Remove the seat cushions.
2.
Remove the wooden fill blocks.
3.
Fold the table leg upwards, while slightly lifting the table, allow
the table to swing down and rest between the two booth seats;
thus, forming the bed.
Figure 5-3. Kitchen Countertops
Figure 5-4. Dinette Booth
Figure 5-5. Filler Strip Attached to the
Seat Portion
Summary of Contents for Allegro Bus 2011
