Tidal Engineering Synergy Compact, Technical Manual, Page: 67 / 346

Synergy Controller Technical Manual, Revision H
Page 67
6.8 Chamber Setup
The Chamber Setup Directory is used for factory setup. The chamber type specified in the Synergy
Controller must match the chamber that it is controlling. The Chamber Type setting maps software outputs
to chamber hardware. Each chamber type has as specific map that is unique to that type of chamber. The
operator should NEVER change this setting. It should only be modified by a qualified technician.
Generic Temperature Only
Generic Temperature/Temperature *
Generic Temperature/Humidity *
Generic Temperature/Humidity Single Stage
Generic Temperature/Pressure
Generic Temperature/Humidity/Pressure
Generic Temperature/Vibration
Retro Temperature Only
The Chambers Types in the list above that are identified with * support VersaTenn retrofit fit applications.
WARNING: Incorrect Chamber Type settings may cause severe damage to your chamber.
Chamber Output Mapping
The Synergy Controller can be configured for many chamber types. Each chamber type has a unique device
output mapping. For example, the fan is driven by Output 1 on Temp-Humidity and Temp-Only chambers,
and by Output 10 for Temp-Temp chambers.
The following tables list the output mappings for the supported chamber types including retrofit
configurations; i.e. when the Synergy Controller is installed on a chamber with a VersaTenn, VersaTenn II or
VersaTenn III.
Output Map Abbreviations:
♦
SM – Switching Module
♦
SSR – Solid State Relay
♦
P# - Olympic Board Connector Labels
♦
J# - Output Board Connector Labels