JTY-GM-TC5401W 无线点型光电感烟火灾探测器安装使用说明书
Ver1.0 202010
辽宁•营口天成消防设备有限公司
6
V. Test
Warning: Please make sure that the polarity of the battery is correct before proceeding.
1. After the module is installed and tested every year during use.
2. Alarm test: After the networking is successful, choose a module to artificially make it meet the alarm
conditions (please turn off the fire alarm linkage function to avoid unnecessary alarm linkage), after the
test, power on again, and notify the relevant management department Restore the system to normal.
3. During the test, the unqualified modules are resolved according to "general failure and repair" and
"maintenance".
VI. Use and operation
1. Network segment setting: The device network segment should be set before the module accesses the
network. In the network setting interface of the control panel menu, set the module access network
segment according to the actual situation on site.
2. The device enters and exits the network:
A) Network access operation: When the control panel is in the "wireless registration interface" and the
module is not connected to the network, quickly press the "Settings" button 3 times, and the green light
flashes 3 times, the module sends a network access application to the control panel, application After
success, the total number of network access displayed by the control panel +1.
B) Network exit operation: When the control panel is in the "wireless registration interface" and the
module is in the network access state, press the "Settings" button 3 times in rapid succession, and the
green light flashes 3 times, the module sends a exit to the control panel After the application is successful,
the total number of withdrawals displayed by the control panel will be +1.
C) Status detection: After the module is powered on, press the "Settings" button once and the green light
flashes once. If the control panel responds to the device, it indicates that the module has successfully
connected to the network, otherwise the module is not connected to the network.
3. Equipment alarm: When the module input terminal receives the closing signal, it sends an alarm signal
to the control panel through wireless communication technology, and the module input red light is
always on.
