4
．
Press a M3 screw nut into the nut slot of the small side of the wind sensor holder, insert wind sensor
holder onto the transmitter holder, establish them with a PM3.0*22mm screw:
5.Insert the wind direction component into the wind speed component, and then insert the wind direction
RJ45 into the 623K hole of the wind speed component. Insert a M3 screw nut into the big side of the
wind sensor holder, and then install the whole wind sensor onto the holder, establish them with a
PM0.3*22mm:
6.Open the battery compartment, install the rechargeable batteries, then cover the battery door. Insert
the whole transmitter onto the long side of the transmitter holder, and establish them with a
PM3.0*18mm screw. At last, insert the wind speed wire RJ45 into the "WIND" 623K hole of the
transmitter:
7.
①
Put the rain gauge wire across the waterproof tower case, and then insert the RJ45 into the 623K
hole of the solar component;
②
Put the solar wire across the waterproof tower case, and then insert the RJ45 into the "RAIN" 623K
hole of the transmitter;
③
Insert a M3 screw nut into the top nut slot of the waterproof tower case, then insert the solar
component into the top of the waterproof tower case, establish them with a PM3.0*8mm screw (Note:
insert the screw from the screw nut side of the solar component):
