THUNDER TIGER ZK2, Instruction Manual

Page: 4 / 8

3
1. Receiver & ESC: Receives the signal from the transmitter to control your vehicle and control the
power input and rotating direction of the motor.
2. Crystal: To change the channel it receives
3. Power Switch: Sliding to turn the unit on or off.
4. Antenna Holder/Tube: Mounts the antenna tube as a transmitter's link.
5. Power Harness Plug: Connects the battery pack to the unit.
6. Steering Servo Socket:Connects the steering servo to the unit.
7. Motor Plug: Connects the motor to the unit to get power supply.
The RS AM Module can be used with 26, 27 or 40 MHz frequency band to operate your vehicle. Each
band has 6 different channels available allowing users to change the crystals for versatile operating at the
same time. When changing the crystal, just replace a set of crystal plugging on transmitter and on
receiver simultaneously by pulling it out. Then push a new set of crystal into the socket carefully on the RS
module and Transmitter respectively. (Caution: do not bend the two pins of the crystal or it would cause
damage of your model.) The following frequency channels are available at 27MHz band.
Each frequency is assigned a colored
flag and channel number. Attach this
flag to the end of your transmitter
antenna so that other modelers can
deter mine your frequency from a
distance. This is very important since
it is not possible for more than one
model to operate on the same
frequency at the same time.
2
4
7
3
5
6 1
The RS Receiver/ ESC (Electric Speed Control) Module
Frequency
CHANNEL FREQUENCY FLAG THUNDER TIGER
BAND COLOR PART NO.
● CH1 26.995 MHz Brown Flag AQ0311
● CH2 27.045 MHz Red Flag AQ0312
● CH3 27.095 MHz Orange Flag AQ0313
● CH4 27.145 MHz Yellow Flag AQ0314
●
CH5 27.195 MHz Green Flag AQ0315
●
CH6 27.255 MHz Blue Flag AQ0316