25.
10
Glue free
Bottom left wing shown
26 .
27.Epoxy the torque rod retainer in place as shown.
Do the same procedure on the other wing.
28
29.
Bottom left wing shown
Trial fit the torque rods, next epoxy the torque
rod in place.
Install the connectors to the torque rods. Next locate
aileron pushrods and clevises, thread clevis on the
pushrod. Connect the Z-bend end of pushrod to
the first hole of the servo horn and snap the clevis
on the connector.
24. Carefully flap the aileron to make sure it moves
freely and the tape is sticky enough to hole the
aileron in place.
Retainer
11
34.
g l u e
33.Trim the vacuum formed radiator as shown and glue
them at the bottom wing.
30
31
32
35.Trim the vacuum formed radiator as shown and glue
them at the bottom wing.
