PARTS CHECK LIST
ASSEMBLY
1. Note the orientation of the rocket launcher wing and
trail fit in the place on fuselage. Ascertain the two wings
are at same dihedral angle, adjust it until you obtain a
satisfactory result, then use pencil to make marks on
the wing at both sides as guidelines.
2. Remove the wing to sand away the paint at the glue
area with150 grid sand paper to enhance the adhesion.
Remove the paint in the wing mount by scratching with
a hobby knife inside the well.
3. Epoxy two wings in the place, either wipe off the
excess epoxy or use masking tape to tape the
guideline to keep the wing root clean after the masking
tape removal. Make sure the two wings are at same
dihedral angles. If you see from the top the wings
should be in line with each other or the rocket launcher
will not be straight forward.
4. Next drill two 5/64" (2mm) holes through the wing
mount to the wing from the inside of the fuselage then
secure the wing firmly with two 3x15mm Wood Screws
at each side.
5. Locate the molded marks for landing strut, screw
holes and engine cooling openings at the bottom of the
fuselage. Note these marks are only for reference of
Raptors, shall you install it on other branded
helicopters then you will have to find out the correct
opening position for landing strut before you drill or
trim the fuselage.
Kit Contents
7
6
Fuselage
Fuselage(1)
Plastic Tube(1)
Tall Boom Foam Retainer(S,1)
Silicon Grommet(3)
Exhaust(1)
Decoration(1)
Silicon Strut Fairing(4)
Windshield
Left Front Window(1)
Right Front Window(1)
Left Rear Window(1)
Right Rear Window(1)
Front Windshield(1)
Tai l
Horizontal Tail(1)
Tip Fin(2)
Tail Skid(1)
Vertical Fin(1)
Body Retainer
Wire Strike(1,S)
Wire Strike(1,L)
Handlebar(2)
Post(2,S)
Post(1,L)
Rocket Launcher
Wing(L,1)
Wing(R,1)
Rocket Launcher Retainer(2)
Rocket Launcher(2)
Rocket Launcher Vent(4)
Landing Skid
Brace(2)
Al.Strut(4)
Skid Joiner(L/2)
Skid Joiner(R/2)
Step Bar(2)
Skid Pipe(2)
Skid Pipe End Cap(4)
Step Bar End Cap(2)
Rear Frame
Rear Frame(L/1)
Rear Frame(R/1)
Washer(2)
Screw
M2 Nut(20)
M2 Washer(4)
M3 Washer(4)
M3 Locknut(2)
2X5mm Screw(20)
2X5mm Wood Screw(44)
2X8mm Wood Screw(12)
3X15mm Wood Screw(4)
3X18mm Wood Screw(7)
3X3mm Set Screw(4)
2.6X10mm Self-Tapping Screw(4)
3X18 mm Self-Tapping Screw (4)
2.6X14mm Socket Screw(8)
3X20mm Socket Screw(6)
3X40mm Socket Screw(2)
3X10mm Washer Self-Tapping Screw(5)
Summary of Contents for MD530
Page 3: ......
Page 8: ...No 4853 15 14...
