19. You may need to install the remote glow plug
extension wire (No.AT6078) for easy igniting as well as
the precision fueler valve (No.1115) for easy fueling.
20. Install a diverter(No.1114 or 1114-Y) and drill an exit
hole at the bottom of the fuselage as shown. You may
extend the diverter to fuselage exhaust pipe to obtain a
more scale-like look.
21. Install the tail transmission case and tail rotor,
remember to replace 3x23mm Socket Screws as
indicated. You may need to trim the fuselage for easy
installation of the ball link in place and clear out the
space for tail pitch control lever.
22. Same to the other side, trim away the fuselage
where you may use tool to secure the locknut.
23. Trim the FRP case cover as shown to avoid any
contact with the transmission case.
24. Glue the plywood doublers at four corners inside
the fuselage. Place the cover in position then drill
1.5mm(1/16”) pilot hole on case and fuselage. Next
Secure the cover in place with 2x8mm wood screws.
25. Cut the LED legs and glue the LED on the Fin for
scale look.
26. Trim windshield, sunroof and windows then trial fit
in place. Carefully make drill marks on windshield (6
marks), sunroof (3 marks each), front side window (4
marks each), front lower window(4 marks each) and
bottom window(3 marks each). Drill 1/16”(1.5mm)
holes then secure the windows in place. Apply tiny
Loctite or CA for each screw to prevent from loose. You
may skip the installation rear side windows as it is
easier for you in case of tuning engine or adjustment
and it also gets better cooling.
27. Install the fittings as shown includes wiper, pitot
tube, antenna.
Drill 2mm hole and use the retaining collar to hold the
fitting in place. After adjusting the fitting properly,
apply tiny CA on the collar to prevent it loosed. For
wiper, secure the strut on the wiper mount with 2x6mm
screw and M2 nut. Apply Loctite on the screw to
prevent it from loose.
28. Drill two holes for handle bar one is 5/64”(2mm)
and the other is 1/32”(1mm).
Secure the handle bar in place with the retaining collar.
Apply CA to prevent it from loose. Do the same way at
the other side.
29. Locate a laser-cut plywood then assemble the
battery tray as shown. Firmly secure the battery tray
with epoxy inside the front fuselage at the very front end.
30. Suggest to use 4-cell 3600mAh NiMH battery
(No.2890) for balance and longer flight time. Secure the
battery in place with rubber band as shown.
11
10
ECUREUIL AS355
ECUREUIL AS355
ECUREUIL AS355
ECUREUIL AS355
Summary of Contents for ECUREUIL AS355
Page 8: ...No 4853 15 14 ...
