Kit Contents
7
6
PARTS CHECK LIST
Fuselage
Top Fuselage(1)
Front Fuselage(1)
Rear Fuselage(1)
Horizontal Tail
Exhaust Pipe (L/1,R/1)
Horizontal Tail (L/1,R/1)
Tail End(1)
Retaining Set
Post(2)
Body Retainer (L/1,R/1)
Windshield
Wind Shield(L/1,R/1)
Middle Window(L/1,R/1)
Sun Roof (L/1,R/1)
Front Window(L/1,R/1)
Rear Window(L/1,R/1)
Front Lower Window(L/1,R/1)
3x8mm Socket Screw (6)
M3 Locknut (4)
M3 Washer (10)
Landing Skid
Brace A (1)
Brace B (1)
Skid Pipe (2)
3x3mm Set Screw (8)
Skid Pipe End Cap (4)
Skid Joiner (4)
Mounting Strap (4)
Silicon Tube (1)
Integrated Wood MNT
Wood Mount (1)
Decal
Decal(1)
3x18mm Wood Screw (8)
3x18mm Socket Screw (4)
M3 Locknut (4)
M3 Washer (8)
POM Washer (4)
Decoration Set
Foot Step Support (4)
Foot Step (1)
Wiper Base (2)
Wiper (2)
Pitot Tube(1)
H/F Antenna (1)
L/F Antenna(2)
Cap(4)
Wiper Mount (2)
Retaining Collar (17)
M2 Nut (2)
2x6mm Screw (2)
Hardware
Screen (L/1)
Screen (M/2)
Screen (S/1)
Tail Boom Foam Retainer(1)
Tie Band(2)
Tail Skid(1)
3X10mm Setscrew
2X5mm Wood Screw(32)
(2)
1. Make sure the Raptor is tested and adjusted before
you install in the fuselage. Once done the testing and
adjusting your Raptor, remove the canopy, landing skid,
tail fins, boom supports and tail rotor assembly.
2. Trim all windows and windshields by using curve
scissors.
3. Sand the glue area of all windows and windshield
as well as at the fuselage inside. This is to increase
adhesion.
4. Epoxy all the windows and windshield to the front
fuselage in place.
5. Locate the upper fuselage, screens and exhaust
pipes as shown.
6. Sand the glue area then epoxy the screens and pipes
in place as shown.
