SpryStep
AFO
4615 Shepard Street Bakersfield, CA 93313
Tele 800.432.3466 - Fax 800.798.2722
www.ThuasneUSA.com
MADE IN USA BY
TOWNSEND DESIGN
4615 SHEPARD STREET
BAKERSFIELD, CA 93313
TEL 661.837.1795
L-0089 REV. A
Footplate Preparation
1.
Tracing Footwear Inlay
•
Use the inlay from the footwear
to measure the template size
(if the inlay is removable)
•
Trace the template onto the
SpryStep footplate
2.
Cutting the Footplate
•
Use scissors to trim the footplate
to the correct template size
•
Note: It is only possible to trim
the blue area with scissors
Fitting instructions
1.
Place SpryStep into Shoe
•
Take the original inlay out of the shoe, if removable
•
The SpryStep should fit into the shoe
with minimal distortion to the shoe
2.
Place Inlay Over the Footplate
•
Place original inlay over the top
of the SpryStep foot plate
•
If the inlay is not removable, disregard this step
3.
Fitting the SpryStep
•
With the shoe laces loose, slide the foot inside
the shoe. You may use a shoe horn if needed
4.
Check the Fit
•
Ensure the heel sits flat on the sole and
that the shoe heel is not distorted
5.
Secure the Calf Strap
•
Feed the straps through the loop
•
If the strap is too long, remove the alligator
tab and trim the strap with scissors
•
Replace alligator tab
•
Fasten strap firmly
6.
Secure the Fit
•
Ensure laces or other fastening
mechanisms are firmly tightened
•
Ensure comfort with no impingements prior to use
1.
3.
5.
6.
