4/6
8.
Press the action button
(2)
onto which you wish to apply the combo that you have just
programmed.
*You cannot program any actions while the LED is flashing.
**If you do not enter an action within 5 seconds the red LED will flash and the entire procedure will be cancelled.
You can program up to 8 different combos (1 per analog action button
(2)
).
Programmable controls:
•
Single control (short press on a button): press the button corresponding to the action you require
and then press the
COMBO
button.
•
Combined control (pressing two buttons at once): press the first button, then press the second
button and finally press the
COMBO
button.
•
Control equivalent to a long press on a direction: push the stick in the required direction and wait
for 5 seconds. The LED turns yellow and flashes for 2 seconds to indicate that a “long press”
action has been registered. Then press the
COMBO
button to confirm.
•
Pause: when programming your sequence, press the
COMBO
button at the point at which you
wish to insert a pause, without programming an action.
•
Stick
movement: to program a stick movement, break down the movement and program each
individual movement separately, pressing the
COMBO
button after each movement.
For example: to enter the
movement:
stick
Í
,
COMBO
button
stick
Ó
,
COMBO
button
stick
Ð
,
COMBO
button
stick
Ô
,
COMBO
button
stick
Î
,
COMBO
button
Using a combo:
Press and hold the
COMBO
button and press the action button onto which you have applied the
combo that you wish to use.
Refer to the example on the following page.
CLEAR FUNCTION
The
CLEAR
button
(10)
allows you to return to the default configuration and delete all activated
functions (Turbo, Program, Combo).
