Thrust Uav 250R PRO, User Manual

Page: 3 / 28

3
USER GUIDE
RIOT SET UP
Install your receiver
WARNING! Remove props and disconnect battery before connecting the RX (receiver).
The Riot is compatible with any PPM, SBUS or DSMX receiver so you can choose the one that works best
for you. For optimum performance, we recommend the FrSky XSR. Depending on the type of receiver,
either solder to the corresponding pads or connect to the Spektrum plug on the flight controller.
WARNING! Do not solder a DSMX receiver to the receiver pads.
For Spektrum RX
For all DSMX receivers, connect to the I.E. SPM4648
Spektrum plug on the flight controller. Spektrum
receivers are only rated for 3.3v and shouldn’t be
soldered to the RX pads.
For FrSky PPM or SBUS RX
Solder a PPM or SBUS receiver such as the FrSky
XSR to the corresponding pads on the flight
controller. With soldering iron in hand, see the
directions below.
a. Remove the top plate of the Riot’s frame using the
included torx driver.
b. Tin the pads on the flight controller.
c. Cut the receiver wires to the desired length. 2
inches is a good place to start.
d. Strip and tin the receiver wires.
e. Solder the receiver wires to the corresponding
pads.
• GND = black
• SBUS = white
• S-port = yellow
• V+ = red
f. Plug the wires into the receiver.
1
a
e
Spektrum RX