This section describes the unpacking and installation procedures for your new
component.
Unpacking
All Thrax Audio shipping boxes have been specially designed to protect their contents
and special care has been taken to prevent damage under normal shipping conditions.
Mishandling should be evident upon inspection of the shipping container. Carefully
remove your new component from its packaging and examine it closely for signs of
shipping damage. We strongly recommend saving all original packaging to protect your
component from damage should you wish to store it or ship it at a later date.
Installation
•
BE CERTAIN TO INSTALL THE UNIT IN A SECURE LOCATION FROM WHICH IT CANNOT FALL
OR TIP OVER
.
•
Provide adequate ventilation - the chassis will become warm in normal use. Do not
operate on carpet or any other surface that might block air flow.
•
Do not allow the chassis to touch any metal parts, such as the frame of an equipment
rack. This might create a parallel ground path that could degrade the sound of your
system.
•
Connect your source's cables to their appropriate inputs.
•
Connect your speakers using the binding posts on either side of the back panel.
IMPORTANT
: READ THE SECTIONS “BACK PANEL”.
WARNING
:
The unit should be operated only at the rated voltage indicated on the power
connector. If you are not sure what the mains voltage supplied to your home is, consult
with your unit dealer.
•
Connect the power supply to the power source indicated on the rear panel. Avoid
power conditioners that float the ground pin. ALWAYS connect power cord to
component before plugging it into an AC outlet, and make sure that unit's main switch is
set to the „off” position before making the final connection. For best performance, try to
route the power cord away from signal cables.
•
Pay close attention to power quality, and be aware that different power cords can
alter the sound.
•
For initial power up press the main switch located on the back panel.
UNPACKING AND INSTALLATION
8
Summary of Contents for ARES
Page 10: ...NOTES ...
