11
Commissioning
Charging the battery
Charging the battery
To charge the battery from your EXPLORER™ terminal, do as follows: Connect the
charger cable, delivered with your EXPLORER™ Bluetooth Handset, to the connec-
tor marked DC OUT on your EXPLORER™ terminal. Connect the other end of the
charger cable to the charger socket at the top of your handset. Make sure the
EXPLORER™ terminal is connected to Mains.
To charge the battery from the charger cradle, do as follows:
Simply place the EXPLORER™ Bluetooth Handset into the charger. It may be
switched on or off. It will remain in the same condition during charging. You will hear
a confirmation tone if EXPLORER™ Bluetooth Handset is switched on.
The battery symbol with three arrows shown here is displayed until the battery is
completely charged.
i
Note
• When you are charging the EXPLORER™ Bluetooth Handset by the charger
socket at the top, you may only use the standard charger cable, which is part of
TT-3625A, and which may only be connected to DC OUT on your EXPLORER™
terminal.
• You can leave the handset in the charger permanently, if you wish. The battery will
be loaded until it is full and then loaded no more - it cannot be ’overloaded’.
• When the battery is being charged, it will become slightly warm. This is perfectly
normal.
• If the battery is completely flat (for example, if the EXPLORER™ Bluetooth Hand-
set has not been charged for many weeks), you should leave the battery in the
charger for at least 30 minutes before switching on and using EXPLORER™ Blue-
tooth Handset.
