Accredited Solution EXPLORER 700 – P3-62W Foldable Solar Panel
Page 4/4
Step 1:
Press the
▼
button.
Step 2:
Press the
▼
button until
SETTINGS appear.
Press OK.
Step 3:
Press the
▼
button until POWER UP MODE
appears. Press the OK button.
Step 4:
Press the
▼
button once and select MANUAL by pressing OK.
Maintenance:
►
Make sure that there is no dirt or moisture inside the connector.
►
When disconnecting a device from the panel, do not pull on the cable; always hold onto the
connector.
►
Keep the front of the panel clean. Do not expose to sharp objects. The panel can be cleaned with
a wet cloth and a mild soap solution when necessary.
You can preserve power by following below guidelines:
►
Point the EXPLORER antenna carefully to obtain best possible signal strength.
►
Upgrade the EXPLORER 700 software version to 2.04 or latest software release (Advanced Power
Management).
►
Switch OFF the EXPLORER 700 when not used for more than 30 min.
►
Turn OFF the interfaces you have no plans of using (please refer to EXPLORER 700 User Manual,
Chapter 4).
►
Set Backlight to Timed (is set to 10 seconds by default).
Need more power?
►
Spare EXPLORER 700 battery (part no. TT-3686P).
Notes:
Although the P3-62W may be used to power other electronic devices the P3-62W has been
optimized to power the EXPLORER 700 terminal. Other electronic devices may be charged at the
consumer’s own risk.
UnatSolar is a registered supplier to armies worldwide. For more information please refer to:
http://www.armedforces-int.com/companies/unatsolar.asp
Tested:
Test performed:
#1
Charging in direct sunlight while being on-line with the EXPLORER 700 terminal and
the EXPLORER Bluetooth Handset ready to receive an incoming call. Total charge
time 2 hours and 40 min.
Information in this document is subject to change without notice and
does not represent a commitment on the part of Thrane & Thrane A/S.
© 2008 Thrane & Thrane A/S. All rights reserved. Printed in Denmark.