Portable Optical Tweezers Kit
Chapter 6: Setup and Adjustment
Rev B, July 8, 2019
Page 43
The next step is to install the electronic controls, see Figure 28, onto the breadboard.
2 x KDC101, LEDD1B, and KLD101 Controllers
First, connect the LEDD1B LED Driver to the MCWHL5 LED and position it on the
breadboard using two 1/4"-20, 1/2" long (M6 x 12 mm) cap screws with washers (the
same type of screws and washers should be used with the following controllers as well).
Then, place the two KDC101 K-Cube Stage controller cubes in their positions, mount
them to the breadboard, and connect them to the computer using USB cables. Next,
connect the KLD101 laser diode controller to the SR9A-DB9 mount, and mount it on the
breadboard. In addition, you must install the supplied software programs for the
operation of the DCC1645C camera and the cubes (KDC101, KLD101). Further
adjustment of the camera and beam path are required for operation. You can find the
instructions for this in Sections 6.3 to 6.5.
Summary of Contents for EDU-OT2
Page 1: ...EDU OT2 EDU OT2 M Portable Optical Tweezers User Guide...
Page 91: ......
Page 92: ...www thorlabs com...
