THOR T2161XBIN, Installation, Use And Maintenance Manual

Page: 4 / 12

4
Care and Maintenance
IMPORTANT : DO NOT PERFORM MAINTENANCE OR CLEANING OF THE EXTRACTOR WITHOUT FIRST
SWITCHING OFF THE ELECTRICITY SUPPLY.
Cleaning
You should use a nonabrasive cleaner. Any abrasive cleaner (including Cif) will scratch the surface and could erase the
control panel markings.
shine with a clean cloth.
Cleaning the (rectangular) grease filter
The grease filter captures grease particles in the air, so is therefore subject to clogging depending on the frequency of
use of the appliance.
In order to prevent fire hazard it is recommended to clean the grease filter at a maximum of 2 month intervals by
carrying out these instructions:
Depending on model, you may have either acrylic or aluminium grease filter(s).
Acrylic grease filter:
1. Remove the cover panel by pushing the fixing clips up and then lifting the panel forwards.
2. Remove the filter retaining wires from the cover panel.
3. Remove the grease filter and wash by hand in a lukewarm solution of water and mild detergent. Once clean
squeeze the grease filter but DO NOT wring it out. Clean the filter holder using a dilute solution of water and mild
detergent or with a damp cloth. Allow the grease filter to dry completely before reassembling the extractor.
4. Replace the grease filter in the cover panel and reattach the filter retaining wires.
5. Replace the cover panel by inserting the lugs on the upper side in the extractor, and then refasten the fixing clips
on the lower side.
Aluminium grease filters:
1. Remove the filters from the cooker hood and wash in a solution of warm water and neutral liquid detergent, leaving
to soak.
2. Rinse thoroughly with warm water and leave to dry.
3. The filters may alternatively be washed in the dishwasher. The aluminium panels may alter in colour after several
washes in a dishwasher. This is not a fault and is not cause for replacing the panels.