14
z
Make the door shut.
z
Be sure the appliance stays secure in the upright position during
transportation.
Also protect outside of appliance with a blanket, or similar item.
Energy saving Tips
z
The Wine Cooler should be located in the coolest area of the room, away from
heat producing appliances, and out of the direct sunlight
6. Troubleshooting
You can solve many common wine cooler problems easily, saving you the cost of a
possible service call. Try the suggestions below to see if you can solve the problem
before calling the service.
TROUBLESHOOTING GUIDE
(a) PROBLEM (b)
POSSIBLE CAUSE
Wine Cooler does not operate.
Not plugged in.
The appliance is turned off.
The circuit breaker tripped or a blown fuse.
Wine Cooler is not cold enough.
Check the temperature control setting.
External environment may require a higher setting.
The door is opened too often.
The door is not closed completely.
The door gasket does not seal properly.
7
3.Installation
¾
Before Using Your Wine Cooler
z
Remove the exterior and interior packing.
z
Before connecting the Wine Cooler to the power source, let it stand
upright for approximately 2 hours. This will reduce the possibility of a
malfunction in the cooling system from handling during transportation.
z
Clean the interior surface with lukewarm water with a soft cloth.
z
The cooler is specially designed for wine storage, please do not put in
other goods.
¾
Installation:
•
The cooler should be placed independently so as to make sure good heat
dissipation. The back of the cooler should be away from the wall 10cm at
minimum.
•
Place your wine cooler on a floor that is strong enough to support it when it is
fully loaded. To level your Wine Cooler, adjust the front leveling leg at the
bottom of the Wine Cooler.
•
Locate the Wine Cooler away from direct sunlight and sources of heat (stove,
heater, radiator, etc.).Direct sunlight may affect the acrylic coating and heat
sources may increase electrical consumption. Extreme cold ambient
temperatures may also cause the unit not to perform properly.
•
Avoid locating the unit in moist areas.
•
Plug in the proper power socket. Make sure that the shape and voltage of the
socket is consistent with the nameplate on the back of the cooler.
