Oct 5
th
2015
www.thonk.co.uk
7
Vactrol Mix
Eurorack DIY Kit
Instructions
Version 1.1
14.
You can now paint the panel, don’t peel off the paper until it is dry!
https://vimeo.com/54711135
Peel off the plastic film off the back too so the LEDs can shine through.
Once it is dry, affix to the PCB and screw on all the nuts and washers provided.
The washers are for the pots.
Do not over-tighten the pot nuts or you can shatter the acrylic panel.
15.
The Vactrol Mix is attached to the GATES output of the BACKPACK. If you also
have a Voltages you just daisy chain it off the Vactrol Mix. Some different
options are shown below for hooking it up.
NOTE!
If you are connecting more than 2 expander modules to a single
BACKPACK (i.e. PULSES, VOLTAGES & VACTROL MIX) then you need to
upgrade the positive rail fuse on the BACKPACK. More info on that here:
https://www.thonk.co.uk/shop/fuse-upgrade/
CONNECTING PULSES ONLY
