Thonet & Vander M6 STUDIO, Operation Manual

Page: 12 / 24

12
FLAT, PRECISE, PROFESSIONAL EN
SYSTEM INSTALLATION
1. M6 Studio™ can be used either with balanced signals or unbalanced signals.
Balanced signals should be connected by XLR connector or TRS connector. Cable
connections must be made in the following way:
Pin 1 and sleeve = ground
Pin 2 and tip=
Pin 3 and ring = signal –
Unbalanced signals must be connected to the RCA connector located on the back
panel. Connect your device output (PC, USB audio interface, mixer) to the matching
input, using good quality cables.
2. Verify voltage selector. It must be in the correct position according to your country
voltage. Make sure the power switch is powered off. Plug the power cable into
the IEC 60320 C14 connector located on the back panel and then plug it into an
electrical socket.
3. Verify that the signal source volume control position is at min and then turn on
the speaker.
4. Play the music you want and adjust volume and treble selector according to your
preference.